GPS 3022- E2160, E8474 Coloured Internal CFC Coating System (Anti-Graffiti)

This spec is for the protection and enhancement of porous surfaces such as fibre cement board in internal environments. It is a low VOC water borne coating system, and is designed primarily for spray application. The system provides good cleaning properties, good hardness, and a beautiful appearance. It is available in any colour, and in gloss or satin finish.

Surface Preparation:

Substrate must be clean and dry

Application

1st Coat – apply Enviroset 2160 Two Pack Water Based Epoxy Sanding Primer to a minimum of 75 microns dry film thickness

The coverage rate is 5 m2 per litre

Allow to fully cure – approx 8 hours drying time

Sand to a smooth, even surface. Level of sanding depends on the finish required – typically between #180 and #400 paper. For maximum flatness and evenness of finish, repeat steps 3 & 4.

2nd Coat – apply Envirothane 8474 Two Pack Polyurethane to a minimum dry film thickness of 50 microns.

The coverage rate is 10 m2 per litre

Applications

Typical applications include decorative walling panels and internal linings

Products

ENVIROSET 2160  is a  two pack water  based  epoxy  sanding primer with excellent  adhesion  to  masonry.  ENVIROSET 2160  is an  easy to  apply  environmentally friendly coating  which  has very good resistance to most chemicals and solvents.  It is surface tolerant and has very low VOCs.

ENVIROTHANE  8474 is a water  borne  two  pack  polyurethane  coating which  gives  excellent  adhesion,  barrier  and  film  properties  on  a  variety  of  substrates.    It  is  easy  to  use  and environmentally friendly, with the added benefit of durability, good yellowing and UV resistance on exterior exposure.  It has good abrasion and chemical resistance.

« Browse more products